Metal roofs installed on Jacksonville homes

Metal roofs shed rain fast, reflect sun and hold up to wind when fastened to their tested pattern, which is why they are popular in Northeast Florida. The choices are the panel type, hidden or exposed fasteners, the metal, steel or aluminum, and the finish, and each changes the cost and the lifespan.

The part you do not see matters as much. Metal moves with heat, so the clips, fasteners and a high-temperature underlayment rated for use under metal are part of the system. We install to the manufacturer's product approval, not a generic nailing habit.

Standing seam panels run from ridge to eave with raised seams locked together over concealed clips, so no fasteners pierce the weather surface. The clips let panels expand and contract without working screws loose, which removes the most common metal roof leak. Mechanically seamed panels suit low slopes and high-wind exposure; snap-lock panels suit most residential pitches.

Panels are cut to length for each slope, so there are no end laps to leak, and the clean lines suit modern and coastal houses alike.

Stone-coated steel panels are pressed into shingle, shake or tile profiles and coated with stone granules, so the roof reads as a traditional covering from the street while carrying the weight and wind performance of metal. They are much lighter than concrete tile, which matters on houses not framed for tile.

Installation uses battens or direct fastening depending on the profile, and cut edges are sealed against rust. The granule surface also quiets rain noise compared with bare metal panels, a common question from homeowners.